Installing hardwood steps does look like an easy task if you just take in notice the overview of its installation but installing hardwood steps is a little more complicated than what we assume it to be. It requires expertise and professional skills to get the whole job done. You can not just plan and start installing hardwood steps just like that. Along with a proper plan, you also need solid information for hardwood installation.
What makes installing hardwood steps complicated is that the hardwood has to be cut according to exact measurements. Any mishap will lead to major problems. The steps are installed with a nailer and noise reduction materials are added to it. Additionally, using stringers is also a good idea for installing hardwood steps. You will have to buy hardwood from any of your favorite local stores before you start working on this project. In case you are not much aware of the quantity, buying some extra steps would save you from meeting inconvenient situations while installing hardwood steps. Then, for getting all prepared for installing hardwood steps, cut the tread boards.
Installing Hardwood Steps
- The very first step of installing hardwood steps is to cut the steps into a required length. Do it and make sure that all the steps share the same length.
- Put some support to the risers, if you consider it important. If it really is important, add bracing using 2x4 screws to fix them tightly into flush of the riser. In this way you can avoid any kind of problems while installing hardwood steps.
- The installation of tread board takes place by using a nailer. Here, you should start from bottom to the top and at the back of steps, nail with the nailer. Proceeding step-to-step will always help you in successful completion of hardwood installation.
- Hardwood steps should be placed against the wall and to proceed with the moldings, you will have to first remove all the railings.
- The nail hole must be filled with like wood putty. Wait until it gets dried completely. Push the nail heads deep into the wood if you have a hammer and add put after that.
- At a right angled degree, slash your hardwood for the landing.
- Fix each board with the rise and the supporting braces.
- Add a noise board to the top landing footstep as your final move of hardwood installation. Make sure that the noising board is cut at a 45 degree.
- Then, you can conclude the floor covering from the noise board and finish installing hardwood steps.
Follow these steps for installing hardwood steps. They do look simple but the most recommended idea is to get help from a professional. |
